When you're done calculating a PRE-Stress project, the data can be published as a report. This is done through the Preview & Print functionality in the File menu. The printout can then be sent to any print-capable device recognized by your operating system.

As the calculation and dimensioning process generates a large volume of information, PRE-Stress allows you to filter the printout to contain the information most relevant to a given project.

Printout options

Settings for beams


The settings can be set for each individual element.

The settings that can be selected are:

  • General information
  • Reinforcement
  • Cross-section data
  • Supports
  • Loads
  • Calculation settings
  • Fire
  • Loadcases per load combination
    • Explanation
  • Max bending table
    • Explanation
  • Max shear table
    • Explanation
  • Recess beam


Each load combination also has individual settings. these might be dependant on what type of element that is being calculated, if topping is present, if it is subjected to torsion or if a punching check can be performed (hollowcore elements with point loads)

The settings here are:

  • General material settings
  • Long term parameters
  • Moment/shear tables
    • Explanation
  • Moment/shear tables (topping)
    • Explanation
  • Topping joint table
    • Explanation
  • Reduced concrete parameters (fire)
    • Explanation
  • Torsion table
    • Explanation
  • Punching

It is also possible to add diagrams

  • Moment
  • Shear
  • Deformation
  • Torsion

In addition, selecting File-> Print general overview will generate and print an overview report, which is a condensed summary of the project data

Copyright 2020 StruSoft AB
PRE-Stress Documentation